This Post is about Lonsdor K518ISE Key Programmer Maintenance, please read it carefully, they can help your Auto key Programmer K518 key programmer in good working efficient and has long service life.
K518ISE on CnAutotool.com Main Unit Maintenance:
1. Place the equipment and accessories in a place where children are not accessible.
2.Keep the equipment in dry and good ventilated environment. Do not use chemicals,
detergents or water to clean the equipment, and avoid rain, moisture or liquid contained
minerals to corrosion electronic circuit boards.
3.Do not store the equipment in over hot/cold place as it will shorten the lifespan of
electronic devices and damage the battery, the temperature range required: low
temperature (-10 ± 3) ℃, high temperature (55 ± 3) ℃.
4.Please do not disassemble the equipment personally, shall you have any problem,please contact
after-sales service or the certified dealer.
5.Do not throw, knock or strongly vibrate the device, it will damage the internal circuit board.
6.If the equipment is in water, make sure it is disconnected and should not be
disassembled personally. Do not use any heating equipment (dryer, microwave oven,
etc.) to dry. Please send the device to local dealer for inspection.
7.After a long time use, such as during working state, long charge, connect OBD to
diagnose, the device may become a slight fever, this is a normal, please do not worry.
8.The device has a built-in antenna, please do not damage or modify the antenna
without authorization, to avoid performance degradation of the device and the SAR value
exceeds the recommended range. As the antenna position will affect antenna performance,
resulting in equipment transmission power in an unstable state, so please try to avoid
holding the antenna area (upper right corner).
9. Do not place heavy objects on the device or squeeze vigorously, to avoid device
damage or display screen distortion.
K518ISE Battery Maintenance:
1.When the device is in start state, please do not remove or maintain the battery. The
inside polymer lithium battery, if not handled properly, may run the risk of fire or burning
itself.
2.Please do not disassemble the battery, do external short-circuit contact, or expose the
battery at excessively high or low temperature (-10°C~55°C as suggested), and do not
dispose battery in fire or as normal waste.
3.Please be careful to keep the battery dry and away from water or other liquids, to avoid
short circuit. If soaked, please do not start the device or remove the battery without
direction.
Leave a Reply