Digimaster 3 Reset Airbag & Control Computer Data

As we know, Yanhua digimaster3 can support automotive odometer adjustment, ECU, Airbag ECU data adjustment, computer program matching, audio decoding, automotive memory programming and key programming. Here mainly share the guide to reset Airbag and control computer data.

How to reset Airbag by Digimaster 3?

Note: After airbag detonation,the error record will be saved in the memory code of circuit board by airbag ECU. If you write the data generated before detonation when the computer hard disk not destroy, then you no need to change the circuit board.

Step1: Enter the Airbag Resetting interface

Choose the relevant model

Here we take Toyota as example

Step2: The airbag will be showed in list by number

Take “Toyota89170-06340” as example

Find out the chip in airbag ECU according to the diagram

Then dismantle the chip to install to OBP adapter, click “next step”

Step3: After finish reading data, it will prompt you whether need to restore airbag

Click “next step”, the data will be restored to airbag chip

2.How to reset Control Computer data by Digimaster 3?

Step 1: Enter “ECU” main menu

Select the corresponding car model

Here take “Passat B4” for example

Step2: According to the diagram

Dismantle the chip and install to ICP Adapter

Click “next step” to go on

Step3: After finish reading data, it will prompt that “it will cover the engine computer data”

then click “next step” to write data into the engine computer

Step4: After all these operations, just need to put the chip back to car

Car models: Audi, Chrysler, Citroen, FIAT, Ford, GM, Honda, Hyundai,KIA, Land Rover, Mazda, Mitsubishi, Nissan, Opel, Peugeot, Renault, SSangYong, Subaru, SUZUKI, Toyota, Volkswagen, Samsung, MG Rover, Cadillac and Luxgen.

Please kindly notice: Here is not full car models Odometer Correction Tool Digimaster III supported, the car models always have been updating…