Why does MDI Explorer display RECOVER

1.Why does MDI Explorer display RECOVER?

This state indicates that someone has initiated the Recover process. The MDI software needs to be recovered.
Connect to the GM MDI Tool with USB.
*   Select ‘Recover’.
*  ‘Start Update’ to perform a software recovery

2.When configuring the MDI to use a fixed IP address for a Wireless or Wired Ethernet interface, which IP address and Subnetwork mask should be used?

The IP address and Subnet mask should be determined by the local IT/Network Administrator. The IP address and Subnet mask must be compatible with the local LAN (Wired) or the AP/Router (Wireless). The IP address must be unique for the network on which it will communicate. If an incorrect IP or Subnet is entered, it may result in address conflicts and/or inability to connect.

3.Why does the MDI Manager indicate that
Access Point information is invalid when I attempt to change the wireless interface’s IP settings?
To communicate wirelessly, the Obd2 tool MDI must connect to the PC through an Access Point. No wireless interface changes can be applied until an Access Point is configured.

4.When configuring a Wireless interface for the MDI, which authentication and encryption level should be used?
It is necessary to access the AP/Router in order to determine these settings. It some cases you are required to contact your IT/Network Administrator for this information. Authentication and encryption level settings are dependent on the Access Point/Router security settings.