How to use OtoSys IM100 perform all keys lost programming for VW Golf 6 2015-2017
Instrument clusters using UDS protocols: VDO 24C64, VDO 24C32, JCI, MM, etc.
Models: Golf 6, Jetta, Passat B7, Polo, Tiguan, etc.
Key programming tool:Auro Otosys IM100 or IM600 (Contact OBD2TOOL Service for IM600)
Take Otosys IM600 and test with Golf 6:
Step 1: connect all the units and the car in a good way
Connect Otosys IM100 to UP400, J2534 programmer and the car via the OBD port
Step 2: select the car and function to do
Select the car: VW 2015-2017
And function: Immo 4 Instrument CAN – All keys lost
Step 3: Otosys Im100 (Im600) works for Golf 6 all keys lost
I.Read immo data
II.Make dealer key
III.Key adaptation to vehicle
In detail…
I.Read immo data
Please turn on the hazard warning flasher
If the vehicle has kessy
Please push down the Start/Stop button
If vehicle has no kessy
Please insert the blank key and then turn ignition
Calculation is completed!
IIMake dealer key
Put a blank key in the programmer key hole and then press OK
Make dealer key successfully
Go to generate the next key
Put a blank key in the programmer key hole and then press OK
Make dealer key successfully
III.Key adaptation to vehicle
The vehicle has no kessy
Communicating with the vehicle…
Learn key:
Please insert in sequence the keys that need to be learned into the ignition switch within 30 s and turn to ON. The keys should be changed at an interval of less than 5s
Numbers of the key learned: 2
Numbers of keys that need to be learned: 2
Key learning completed!
Turn ignition off and wait for 5 seconds
Turn ignition switch on
I.Read immo data: completed!
II.Make dealer key: completed!
III.Key adaptation to vehicle: completed!
Tested with the car…works good
Key Programmer Otosys IM100 (IM600) Golf car list:
Leave a Reply